Toro Reelmaster 7000-D Operator's Manual page 20

toward you to the most comfortable position and then
release the pedal.
Mow-Speed Limiter
When the mow-speed limiter
it will control the mow speed and allow the cutting
units to be engaged. Each spacer adjusts the mowing
speed by ½ mile per hour. The more spacers you
have, on the top of the bolt, the slower you will go.
For transport, flip back the mow-speed limiter and you
will have maximum transport speed.
Speed-Limiter Screws
Adjust the screw(s) (Figure
the traction pedal can be pressed in the forward or
reverse direction to limit speed.
Important:
The speed-limiter screw must stop
the traction pedal before the pump reaches full
stroke or damage to the pump may occur.
1. Reverse speed limiter
screw
2. Forward speed limiter
screw
Lower Mow/Raise Control Lever
This lever (Figure 27) raises and lowers the cutting
units and also starts and stops the reels when the
reels are enabled in the mow mode. The cutting units
cannot be lowered when the mow/transport lever is
in the transport position.
Key Switch
The key switch (Figure
O /P , and S
N REHEAT TART
InfoCenter
The InfoCenter LCD display shows information about
your machine such as the operating status, various
(Figure 26) is flipped up
26) to limit the amount
Figure 26
3. Spacers
4. Mow speed limiter
27) has 3 positions: O
.
diagnostics and other information about the machine
(Figure 27).
PTO Switch
The PTO switch
and S . Push the PTO button forward to engage
TOP
the cutting-unit blades. Push the button back to
disengage the cutting-unit blades.
1. Lower mow/raise control
lever
2. Key switch
3. InfoCenter
Engine-Speed Switch
The engine-speed switch
change the engine speed. By momentarily tapping
g015075
the switch, you can increase or decrease the engine
speed in 100 rpm increments. Hold the switch down
to move the engine speed directly to high or low idle,
depending on which end of the switch is pressed.
Headlight Switch
Pivot the switch downward to turn on the headlights
(Figure 27).
Power Point
Use the power point
12-volt electrical accessories.
,
FF
20
(Figure 27) has 2 positions: S
Figure 27
4. PTO switch
5. Engine-speed switch
6. Headlight switch
(Figure 27) has 2 modes to
(Figure 28) to power optional
TART
g021208