Adjusting The Support Rollers; Replacing The Warning Decal For Ce Compliance; Installing The Hood Lock For Ce Compliance - Toro Reelmaster 7000-D Operator's Manual

1
Adjusting the Support
Rollers
No Parts Required
Procedure
Depending on what width cutting units are to be
installed on the traction unit, adjust the support rollers
as follows:
Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove the
key.
•
If using 27 inch cutting units, install the rollers in
the upper mounting holes of the support assembly
channels (Figure 3).
•
If using 32 inch cutting units, install the rollers in
the lower mounting holes of support assembly
channels (Figure 3).
1. Support assembly channel 3. Use this hole for 32 inch
2. Use this hole for 27 inch
cutting units.
Figure 3
cutting units.
2
Replacing the Warning
Decal for CE Compliance
Parts needed for this procedure:
1 Warning decal
Procedure
On machines requiring CE Compliance, affix the CE
warning decal (Part No. 120-1686) over the standard
warning decal (Part No. 120-1683).
3
Installing the Hood Lock for
CE Compliance
Parts needed for this procedure:
1 Hood-lock bracket
2 Rivet
1 Screw (1/4 x 2 inch)
2 Flat washer (1/4 inch)
1 Locknut (1/4 inch)
Procedure
1. Unhook the hood latch from the hood-latch
bracket (Figure
g019541
11
4).