LCD menu shows the total current. Hold the Switch/Set button for 3 seconds (until a long
beep is heard) to enter alarm current setting. Press the Switch/Set button to increase the alarm
current by 0.5A in each press. Hold the Switch/Set button for 3 seconds (until a "beep" is
heard) to save the setting.
Press the Switch/Set button until it shows the maximum current. Hold the Switch/Set
button for 3 seconds (until a long beep is heard) to adjust to a zero point.
Press the Switch/Set button to switch the display of each IP address.
IP-based 4/8-port Switched Power Manager Power
16
-
-
IPM-4220 / IPM-8220