Planet IPM-4220 User Manual page 19


Press the Set button to show the voltage information.

Press the Set button to show the maximum current record of all branches (branch 1 and
branch 2).  Hold the Set button for 3 seconds (until a long beep is heard) to adjust to a zero
point.
IPM-8220 Power Outlet Panel Operation
When the LCD panel shows figures and "0", the information shown is the branch circuit power outlet.
By clicking the Set button, the following information will be displayed in sequence:

Press the Switch button to Port 1~8 mode.

Press the Set button to show power outlet current.  Hold the Set button for 3 seconds
(until a long beep is heard) to enter power outlet alarm current setting.  Enter flash mode (LCD
will flash after entering setting mode; "S", "O" and "W" will display at the bottom of LCD).  Press
the Set button to increase the alarm current by 0.5A in each press.  Hold the Set button for 3
seconds (until a "beep" is heard) to save the setting.

Press the Set button to show "maximal power outlet current record",  Hold the Set
button for 3 seconds (until a long beep is heard) to adjust to a zero point.

Hold the Switch button for 3 seconds (until a long beep is heard) in Port 1~8 mode. 
Enter Power On/Off mode ("L" will be added in front of the original line number).  Double-click the
Set button to switch between power on and off.

When LCD panel displays " Port 1~8 mode".  Hold the Switch button for 3 seconds (until a
long beep is heard) till "LOC" displayed. It means this circuit power is locked and cannot be
IP-based 4/8-port Switched Power Manager Power
19
- -
IPM-4220 / IPM-8220