Control Board; Control Terminal Strip X2A - KEB COMBIVERT F5 SERVO Installation Manualline

Installation and Connection
3.5

Control board

3.5.1 Control terminal strip X2A

• Tightening torque 0,22...0,25 Nm (2 lb inches)
• Use shielded/drilled cables
• Lay shield on one side of the inverter onto earth
potential
NPN control is not possible at the A servo !
PIN Function
1 + Set value input 1
2 - Set value input 1
5 Analog output
7 +10V output
8 Analog ground
10 Progr. input 1
11 Progr. input 2
12 Progr. input 3
13 Progr. input 4
16 Voltage supply
driver stage
18 Transistor output 1
19 Transistor output 2
21 Voltage supply
Control board
22 Digital ground
24 Relay 1 / NO contact
25 Relay1 / NC contact
26 Relay1 /
switching contact
14
Name Description
AN1+ Differential voltage input
AN1- 0...±10 VDC ^ 0...±maximum speed; Ri = 55 kÙ
AN Programmable analog output 0...±10 VDC / 5 mA;
OUT1 Function is defined by the machine builder
CRF Reference voltage output for set value potentiometer
(+10 VDC / max. 4 mA)
COM Ground for analog in- and output
I1 The function of the programmable inputs is defined by
I2 the machine builder.
I3 Switching voltage 13...30 VDC ± 0 % smoothed
I4 Ri=2,1 kÙ
ST Supply of the driver stage
This input must be supplied with an external voltage of
20...30 VDC ± 0 % / 0,2 A (U
switching off this voltage an error reset is executed.
O1 Programmable digital output 1 and 2
O2 Load capacity maximal 50 mA for both outputs
Function is defined by the machine builder
Uin Supply of the control
This input must be supplied with an external voltage of
20...30 VDC ± 0 % / 0,8 A (U
the separate supply the control can also be operated at
switched off driver/power section.
0V Reference potential for digital inputs/outputs
FLA Programmable relay output
FLB Load capacity max. 30 VDC / 0,01...1 A
FLC Function is defined by the machine builder
X2A
1 2 5 7 8 10 11 12 13
max. 3,6 Vss). When
BR
max. 3,6 Vss). Through
BR
16 18 19 21 22 24 25 26