Vision Engraving & Routing Systems Express User Manual page 99

Step by Step Operation 99
Send the job to the engraver as a dry run to determine whether or not the job is positioned correctly. If it
is, you are ready to engrave the item. If the positioning is not correct, you can either adjust the graphics
within the Vision 9 software, or correct the custom home position.
Hint - It may be useful to send a dry run job to the engraver that includes a simple rectangle that is
slightly smaller than the engraving area, as shown below. The Red Dot Laser Pointer will follow the
path of this rectangle and outline the engraving area. This can make it much easier to see if your
home position and engraving area is located properly before sending the final job to the machine.
© 2015 Vision Engraving & Routing Systems