Vision Engraving & Routing Systems Express User Manual page 102

102 Vision Express User Manual
Select the Shape Tools icon from the left toolbar, then select the Circle tool (or the Rectangle tool for
rectangular areas).
Click, hold and drag a circle (or rectangle) of any size. When using a circle, enter the radius of the
circle (1.50 for this example) in the Circle Radius field on the top toolbar. Press the Enter Key to retain
this setting.
Deselect the Circle tool by clicking anywhere outside of the circle, then move the circle by clicking,
holding and dragging from the center node of the circle until it snaps to the guidelines you have drawn.
(If you have a rectangular area, deselect the Rectangle Tool by clicking once outside of the rectangle
you have drawn, then click, hold and drag from the middle nodes of the sides of the rectangle until each
side of the rectangle snaps to the appropriate guideline - the bottom line of the rectangle snaps to the
bottom guideline, the top to the top, etc.)
© 2015 Vision Engraving & Routing Systems