Vision Engraving & Routing Systems Express User Manual page 112

112 Vision Express User Manual
Apply isopropyl alcohol to a paper towel and wipe down the X-Axis (carriage) leadscrew and the
stainless steel rail for the carriage. Move the carriage and spindle to access all areas of the leadscrew
and rail.
Apply isopropyl alcohol to a paper towel and wipe down the leadscrew and the stainless steel rail for the
t-slot table.
NOTE: Clean the leadscrew, rail and baseplate (the area underneath the table) with the table in the fully
extended (forward) and fully retracted positions.
© 2015 Vision Engraving & Routing Systems