Part Ii General Information; Unpacking And Taking Inventory - Vision Engraving & Routing Systems Express User Manual

2 General Information
2.1

Unpacking and Taking Inventory

The Vision Express engraving system has been shipped in one carton, unless other accessories have
been ordered with the machine that will not fit in the box. Examine the condition of the box for external
damage. In the event of apparent external damage, notify your shipping carrier upon receipt, and call
your sales representative or Vision immediately.
Note: The shipping container is considered reusable and should be stored for use in the event of
service need or upgrade.
Step1:
Open the foam packed shipping carton. In the top of the carton will be a cardboard box with all of the
machine accessories (including this manual). The following items should be included:
1 Vision Express Machine
1 Vision Express Warranty Card
1 Vision Express Installation Guide
1 White/Blue or Orange USB security dongle - Contains User Manual and Vision Software
1 Ethernet Network Cable
1 Crossover Cable
1 Power Cord
1 External Power Supply
1 0.015 FLX Plastic Cutter
1 Diamond Drag Cutter
1 6 x 8 inch Multi Mat Material
1 Spare Motor Belt
1 Allen Wrench Set
1 Cutter Wrench
1 Technical Support Label
1 Delivery and Sign-off Sheet
1 Accessory Sheet
Check to see that all of the items are included. Should any of the contents be missing, damaged, or of
the incorrect type, please call your sales representative or Vision immediately.
Step 2:
Prepare a clean, level surface to put the engraving machine on. Carefully lift the machine out of the
carton and place it on the table.
Step 3:
After unpacking the machine, make sure that you SAVE THE CARTON, FOAM PACK and ANY
OTHER BOXES. They can be reused in the event the system must be transported to another
location or returned for service. Improper packaging for shipment can damage the machine and may
void the warranty.
© 2015 Vision Engraving & Routing Systems
Introduction 9