Vision Engraving & Routing Systems Express User Manual page 82

82 Vision Express User Manual
After selecting OK, the Dry Run job file is sent to the machine. Place the material on the table and make
sure the engraver is set up as in Rotary Engraving section before running the file. If the Dry Run shows
proper job setup, send the job to the machine with the Dry Run turned off. Use the proper cutting tool for
the engraving application. After pressing Start and finishing the job,the engraved portion of the file
should appear as shown.
Cutting
After sending the engrave file to the machine, the Filter by Color window will re-appear, signaling that
the software is ready for you to send another file to the engraver. Since we need to change the material
setting, select Stop Cutting.
Select the Engrave icon from the left side toolbar, then select Cancel from the Filter by Color window.
© 2015 Vision Engraving & Routing Systems