Vision Engraving & Routing Systems Express User Manual page 98

98 Vision Express User Manual
When sending the job to the engraver, select the Engrave icon from the left toolbar, but before
selecting Engrave from the Cut Toolbox, you MUST choose the new home position from the
Tool Setup window. Select the Tool Setup options icon (which looks like three dots) from the
Engrave Menu Bar, as show below.
The Tool Setup window will appear. First, select the appropriate material setting from the Material drop
down list, then in the Preset Home Position field, change the home position to the number that
corresponds to the home position you set in the Jogger window (in this example, home position 1).
Make sure there is a check mark in the box next to the Preset Home Position field. The check mark tells
the machine to use this preset. Select OK to close this window. The home position is saved with the
material settings, so if you change materials, you must also change the home position for that material.
All files sent to the engraver using this material will now use Home Position 1 as the 0,0 (upper left
corner) of the engraving area. When you want to return to using the default Home Position, open the
Tool Setup options window (after selecting the Engrave icon from the left toolbar) and set the Preset
Home Position back to 0, then click on OK.
© 2015 Vision Engraving & Routing Systems