Cleaning The Drum/Paper Separator; Cleaning The Fuser Roller - Atari SLM804 Series Owner's Manual

For all atari st computers

Hide thumbs Also See for SLM804 Series:

Table of Contents

////////////////

Cleaning the Drum/Paper Separator

You should clean the drum/paper separator every time you replace

the toner or whenever you notice excess toner building up on the

separator. The drum/paper separator is a thin, clear plastic band

located on the left underside of the

dr.

u m; it separates the paper

from the drum after the toner is applied. To clean the drum/paper

separator, follow these steps:

1. Open the top cover without releasing the drum and toner hopper.

2. Gently run the cotton swab you received with the toner kit under

and over the separator. Be careful not to break the band while

cleaning it.

Drum/Paper Separator

3. Close the top

cover.

Cleaning the Fuser Roller

You should clean the fuser roller every time you replace the toner.

The fuser roller fuses the toner onto the

paper.

To clean the fuser roller, follow these steps:

Warning:

The fuser and the surrounding felt-covered surfaces

inside the printer get extremely hot whenever power to the printer

is switched on

Wait at least two hours after switching off the

printer before you perform any procedure near these

surfaces.

Table of Contents