Motor Parameter Setup And Calibration - Idex Pulsafeeder MPC Vector Installation, Operation & Maintenance Manual

11.1

Motor Parameter Setup and Calibration

1. Navigate to the
PARAM option. The starting display will be:
2. Press the ENTER key
3. Use UP and DOWN arrows to adjust value as required, then press the ENTER key
4. Use UP and DOWN arrows to adjust value as required, then press the ENTER key
5. Use UP and DOWN arrows to adjust value as required, then press the ENTER key
6. Use UP and DOWN arrows to adjust value as required, then press the ENTER key
7. Use UP and DOWN arrows to adjust value as required, then press the ENTER key
8. Press the ENTER key (Note: calibration may take up to a minute)
9. The last screen will show
10. Upon completion of the routine, remove power from the MPC VECTOR controller for one minute, and then
re-apply power to complete the process.
CALIBRATION menu and press ENTER, and scroll (UP/DOWN) to the
C A L I B R A T I O N
M O T O R P A R A M
M O T O R R A T E D R P M
< 1 7 5 0 >
M O T O R C U R R E N T
< 1 . 2 >
M O T O R V O L T A G E
< 2 3 0 >
M O T O R F R E Q U E N C Y
< 6 0 >
M O T O R P W R F A C T O R
< 0 . 8 0 >
E N T E R T O S T A R T
C A L I B R A T I N G
M O T O R P A R A M
C A L I B R A T E D
64
MOTOR