Normal System Operational Modes - Idex Pulsafeeder MPC Vector Installation, Operation & Maintenance Manual

Digital I/O
Analog I/O
System Setup
1.2.4

Normal System Operational Modes

1.2.4.1 Manual (Local) Operational Mode
Manual (also referred to as Local) operational mode requires that the user be present at the pump user interface
(hand-held unit) in order to operate the pump (Note: this location may be up to 1000 ft from the pump). This
mode is indicated by the manual LED being illuminated. A user may, at any time the pump is running, place
the pump into the off condition by pressing the Motor ON/OFF key
Manual mode of operation, using the Auto/Manual key
Parameters pump motor.
PulsaGuard Provides setup of run dry feature and calibration
Digital Input Allows enabling the input, defining whether active high or low,
1&2 and defining its use
Digital Output Allows enabling the output, defining whether active high or low,
1,2 &3 and defining its use
Analog Input 1 Allows activation of the 4-20 mA analog input for open loop
speed or closed loop flow control.
Status Provides history of pump status and errors (up to last 4)
Language Allows user to select language
Factory Init Restores pump to factory settings
Flow Units Allows user to set pump flow units GPM, GPH, LPH, LPM
Information Displays system software levels, performing digital/analog
diagnostics, set system turndown, setting pump max flow rate and
speed
Flow Detect Allows setting of flow detection delay time for flow detect digital
input
Flow Meter Allows activation/deactivation of flow meter for closed loop flow
control
Security Enables/Disables and sets password protection number
PulsaGuard Activate/ Deactivate Run Dry sensing
PID Parameters Allows setting of proportional, integral, and derivative parameters
for closed loop flow meter based systems
TCF Allows the user to change AC drive parameters to suit
Parameters motor/pump application.
Table 1-3 MPC Vector System Configuration Menu Items
or place the controller into the
.
5