Controller Mounting And Layout; Nema 4X Version - Idex Pulsafeeder MPC Vector Installation, Operation & Maintenance Manual

A
VOID LOCATIONS WHERE THE
[ 0 C
LESS THAN
DIRECT SUNLIGHT
ITS WARRANTY
The MPC VECTOR is provided in two form factors, a NEMA 4X enclosure, and an OPEN CHASSIS custom
mountable panel.
5.2.1

Controller Mounting and Layout

The MPC VECTOR is provided in two form factors, a NEMA 4X enclosure, and an OPEN CHASSIS custom
mountable panel.
5.2.2

NEMA 4X Version

The NEMA 4X design, both 230VAC and 480 VAC, of the MPC VECTOR incorporates all control circuitry onto
one easily accessed control panel. This controller circuitry is located on the inside of the main controller enclosure.
Gain access to this circuitry by removing the 2 cover screws to the hinged enclosure. See Figure 5-2 – NEMA 4x
Figure 5-1 – Typical Installation (Gear Pump Shown)
MPC VECTOR
(32 F
ELSIUS AHRENHEIT
. F
AILURE TO OBSERVE THIS WARNING COULD DAMAGE THE
.
WOULD BE SUBJECTED TO EXTREME COLD OR HEAT
40  C
)
OR GREATER THAN
12
(104  F
ELSIUS AHRENHEIT
MPC VECTOR
)]
OR
AND VOID