Table of Contents
Advertisement
Step 1
Confirm Handheld Remote Operation
Step 2
Set flow units
Step 3 (Optional)
Set AC Line Voltage
Only for 200-208 and 380-400 VAC installations
Step 4
Set the Pump maximum flow and maximum Speed
Motor parameter setup and calibration (Note: pump
Step 5
rotation may not occur if motor not calibrated)
ONLY IF USING FLOW METER: If using closed loop
Step 6 (Optional)
flow control, Flow Meter Activation. Test flow meter 4-
20 input
Step 7 (Optional)
Activate and Configure Digital Inputs and Outputs
Step 8(Optional)
Testing Digital I/O
Step 9
Flow calibration
Analog Output signal setup, test, and calibration
Step 10 (Optional)
28
Section 6.3
Confirm Display
Section 6.5
Flow Display
and
Units
Section 10
AC Input Voltage
Setting
Section 6.6
Setting Max Flow
and Max Speed
Section 11
Motor Parameter
Setup and Tuning
Section 9
Flow Meter Input
Section 7.2 and 7.4
Digital Input
and
Digital Output
Section 7.2.2
Test Digital Inputs
Section 7.4.2
Test Digital Outputs
Section 8.1.1
Open Loop Pump Flow
Calibration
Section 8.1.2
Closed Loop Pump
Flow Scaling and
Calibration
Section 8.1.4
Analog Output
Calibration
Advertisement
Table of Contents
Troubleshooting
