Factory Re-Initialization - Idex Pulsafeeder MPC Vector Installation, Operation & Maintenance Manual

6.8 Factory Re-Initialization

Factory Re-initialization is typically not required. When re-initializing your MPC VECTOR, all of the
current system settings and calibration information will be overwritten by the original factory default
settings. The controller must be re-configured and re-calibrated to your specifications.
A Factory Re-initialization should be performed only if there is reason to believe that the MPC VECTOR is
operating abnormally. The condition usually manifests itself with inconsistent or erratic operation – often
associated with meaningless characters on the display, or exaggerated numerical values. Commonly, a user has
entered incorrect parameters, or made changes to the setup of the control.
Once a re-initialization has been performed, all operating parameters should be checked and adjusted or re-entered
as necessary, including maximum flow and rpm, motor parameters, flow and analog signal calibrations, etc.
Factory Re-Initialization:
1. Press the MENU key to access the System Setup Menu
2. Press the UP arrow key to display
3. Press the ENTER key
4. Press the UP arrow key twice
5. Press the ENTER key
6. Press the ENTER key
7. Pres the ENTER key
- M E N U -
C A L I B R A T I O N
- M E N U -
S Y S T E M S E T U P
S Y S T E M S E T U P
S T A T U S
S Y S T E M S E T U P
F A C T O R Y I N I T
P R E S S E N T E R
T O F A C T O R Y I N I T
A R E Y O U S U R E ?
Y E S = E N T E R N O = M E N U
R E S E T T I N G P U M P
T O F A C T O R Y I N I T
33