Ac Input Voltage Setting - Idex Pulsafeeder MPC Vector Installation, Operation & Maintenance Manual

10. AC Input Voltage Setting

Warning: Do not set this parameter if your installation line voltage is 230 or 480 VAC.
If your AC line input voltage is 200-208 VAC or 318-400 VAC then you must set parameter number 01 to a
value of 2, indicating low line voltage to the AC drive. The AC drive needs this voltage calibration in order
to monitor bus voltages and motor current, ensuring protection of your pump motor.
1. Starting from the main operational screen
2. Press the MENU key
3. Press the UP arrow key
4. Press the ENTER key
5. Press the DOWN key
6. Press the ENTER key
7. Press the ENTER key
8. Press the UP arrow key
9. Press the ENTER key
10. Press the MENU key
11. Approximately 2 seconds
S E T P T
F L O W
- M E N U -
C A L I B R A T I O N
- M E N U -
S Y S T E M S E T U P
S Y S T E M S E T U P
S T A T U S
S Y S T E M S E T U P
T C F P A R A M E T E R S
P A R A M 0 1
V A L U E
P A R A M 0 1
V A L U E < 1 >
P A R A M 0 1
V A L U E < 2 >
P A R A M 0 1
V A L U E
T C F P A R A M E T E R S
A C T I V E
S Y S T E M S E T U P
T C F P A R A M E T E R S
61
X X . X X X
X X . X X X
1
2