Equipment Inspection; Storage Instructions; Short Term (0 - 12 Months); Long Term (12 Months Or More) - Idex Pulsafeeder MPC Vector Installation, Operation & Maintenance Manual

Universal control for pulsa and eclipse. suitable for any gear, reciprocating or positive displacement pumps.

Table of Contents

3. Equipment Inspection

When you receive your order, check all equipment for:



Completeness against the shipping document / purchase order



For any evidence of shipping damage

Shortages or damage should be reported immediately to the carrier and your Pulsafeeder Representative.

The MPC VECTOR can be successfully stored for extended periods. The key to successful storage is dependent on

temperature and humidity control.

The MPC VECTOR should be stored in a temperature and humidity controlled environment. It is preferable to

keep the temperature constant in the range of -18 to 60 Celsius (0 to 140 Fahrenheit). The relative humidity

should be 0 to 90% non-condensing.

Storage of the MPC VECTOR for periods of longer than twelve months is not recommended. If extended storage

is unavoidable the MPC VECTOR should be stored in accordance with those conditions stipulated for Short Term

Storage. In addition, a porous bag of 85g (3 oz) silica gel or similar desiccant should be placed inside the

enclosure. The cover should be re-installed to seal the desiccant within the enclosure. The conduit connections

must be tightly capped.

Special note for long-term storage:

If AC input power has not been applied to the MPC VECTOR for a period greater than 12 months, the controller

must be prepared for operation. The MPC VECTOR should have AC power applied at the input for a period of 8

hours before placing pump into normal operation. Refer to Installation and Wiring section for AC power

connection instructions.

Table of Contents