Wrapping Up - Idex Pulsafeeder MPC Vector Installation, Operation & Maintenance Manual

11) Press the ENTER key again to save the Max Flow and Max Speed. Note that the blinking cursor should
disappear at this point.

6.7 Wrapping up

Your MPC VECTOR is now commissioned for use. Note that you cannot configure the software in a way that
would damage the MPC VECTOR. Typically, whenever you are about to set a critical value (e.g., Calibrate Flow),
you are always prompted to confirm your change before it takes effect. If you are ever dissatisfied with the
configuration of your MPC VECTOR, you can always return to the Factory Defaults by referring to Section 6.8
Factory Re-Initialization.
M A X : 8 . 5 0 G P M
M A X : 1 8 0 0 R P M
M A X : 8 . 5 0 G P M
M A X : 1 8 0 0 R P M
32