Configure Library: Ipsec The Policy Setting Page - IBM TS3100 Setup, Operator, And Service Manual

- StrongSwan/Racoon2
– VPN router or similar devices
Important: Configuring IPSec can be complex. Therefore, do not enable IPSec or change the IPSec
settings unless you are directed to do so by an IPSec knowledgeable person who is familiar with the
devices that are attached to your network.
IPv6 must be enabled to use IPSec on IBM TS3100/TS3200 libraries. If the protocol stack does not include
IPv6, you cannot edit any related IPSec pages. To use IPSec, on the Network page set the Protocol Stack
to Dual stack IPv4 + IPv6 or IPv6 only.
The IPSec Settings page controls the generic behavior of the IPSec system and contains the policy
management.
1. Click IPSec in the left navigation pane to display the IPSec menu page.
Figure 114. Configure Library: IPSec The Policy setting page
2. Select Enable to enable or disable IPSec. A check mark displays when IPSec is enabled. When the
check box is clear (as in the following graphic), IPSec is disabled.
Important: To configure IPSec with the appropriate layers of security services, ensure that policies on
the host AND device sides are enabled. If unsure how IPSec security works, contact your Network
personnel.
Figure 115. Generic IPSec settings
136
IBM TS3100 Tape Library and TS3200 Tape Library: Setup, Operator, and Service Guide Machine Type 3573