Choose Left or Right to unlock the corresponding cartridge magazines. The magazines are removed from
the library by gently pulling each magazine out of the library. To replace a magazine, insert the back of
the magazine into the front of the library and gently push the magazine into the library. The magazine
locks when inserted into the library.
Attention: After inserting the magazines into the library, you must wait for the library to complete its
inventory before proceeding with normal library operations.
If the magazines are not pulled out of the library within 15 seconds after they are unlocked, the
command cancels and you must repeat the process to unlock the magazines.
Control: Re-Inventory
Use this menu item to initiate a scan of the cartridges in the library.
Control
Re-Inventory
Figure 74. Control: Re-Inventory menu
Note: It might take up to five minutes to complete the library inventory.
Configure menu
The Configure menu is used during the initial setup of your library and when changes need to be made
to your library's configuration. This menu contains the following items:
v Logical Libraries
v Library Settings
v Drive
v Network
v Set Access PIN
v Save/Restore
v Set Date and Time
Configure: Logical Libraries
Use this menu item to select the number of logical libraries. The Currently Configured - x section shows
the number of logical libraries that are configured.
98
IBM TS3100 Tape Library and TS3200 Tape Library: Setup, Operator, and Service Guide Machine Type 3573