Configure: Set Date And Time; Configure: Path Failover; Configure: Set Date And Time Menu - IBM TS3100 Setup, Operator, And Service Manual

Table 26. Factory default settings (continued)
Restored Item
OCP Access PIN
SSL for Web
Drives
Power
Drive 1 SCSI-ID
Drive 2 SCSI-ID
Drive 3 SCSI-ID
Drive 4 SCSI-ID
Drive 1 Loop-ID
Drive 2 Loop-ID
Control Path Drive
Speed
Topology
IPv6 Stateless Autoconfig
Note: * = all settings at library firmware level 4.xx and greater
In some cases (such as Library Mode), the entry of one option precludes any other options from being
selected. In such cases, the details of the non-applicable options are not shown.

Configure: Set Date and Time

Use this menu item to set the date and time in your library.
Figure 82. Configure: Set Date and Time menu

Configure: Path Failover

Use this menu item to enter the Path Failover Feature Activation key (Supported on 4U library only for
library firmware levels at or below 8.xx. Supported on both the 2U and 4U libraries with library firmware
levels above 8.xx).
Default Setting*
Disabled
Note: The initial Factory Default
setting is disabled. If the OCP Access
PIN setting is changed, running
"Restore Defaults" does not change
the setting.
Disabled
Power On
4
5
6
8
4
5
Drive 1 only
Auto
LN-Port
Enabled
Configure
Set Date
and Time
Comments
If OCP Access PIN is enabled, the
default PIN is "1234".
(All drives)
SCSI Drives
SCSI Drives
SCSI Drives
SCSI Drives
FC Drives Arbitrated Loop
FC Drives Arbitrated Loop
FC Drives (all)
FC Drives (all)
Operations
107