Replacing Cartridge Magazines; Replacing Magazine Fiducials - IBM TS3100 Setup, Operator, And Service Manual

Tape library
Table of Contents

Advertisement

10. After power is restored to the library controller card, the library automatically restores the VPD on
the new library controller card from the library enclosure. If a VPD Selection message is displayed in
the Operator Control Panel, see the Read Me before Continuing section earlier in this procedure to
determine how to respond to the message.
11. Upgrade library firmware and drive firmware to the latest version. See "Service Library: Upgrade
Firmware" on page 156.
12. Run the Library Verify test (refer to "Service: Library Verify" on page 108).
Note: Use care when you select the appropriate VPD to restore from/to. An error in selection here
might cause a long downtime.
13. Package the failed library controller card in the same packaging in which the new control board was
shipped to you and return to IBM. Complete the Warranty Redemption form and return it in the
package with the library controller card.

Replacing cartridge magazines

To replace a cartridge magazine, see one of these procedures:
v Web User Interface: "Manage Library: Release Magazine" on page 122.
v Operator Control Panel: "Control: Magazine" on page 97.
v If your library cannot be powered ON: "Releasing the magazines manually" on page 215.

Replacing magazine fiducials

About this task
Magazine fiducials are location sensors that are used by the library accessor.
Check, adjust, remove, and replace
233

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ts3200

Table of Contents