Testing Encryption Configuration For Library Managed Encryption; Restoring Factory Default Settings; Logging Out Of The Web User Interface; Configuring Your Library With The Operator Control Panel - IBM TS3100 Setup, Operator, And Service Manual

v Privacy Password - The Privacy Password must be at least 8 characters in length.
Note: The factory default settings for SNMP V3 Security are
v User Name - initial
v Authentication - none
v Privacy - none

Testing encryption configuration for Library Managed encryption

About this task
If you purchased an encryption activation key (Feature Code 5900 - Transparent LTO Encryption) and any
LTO 4 or higher Fibre Channel or SAS drive in your library, and the library is configured for library
managed encryption, run the Key Path Diagnostic to ensure that your encryption configuration is correct.
Important: Ensure that library firmware and drive firmware are up to date before the Key Path
Diagnostic procedure is run. Library firmware level must be greater than 6.xx. See "Verifying/updating
firmware" on page 60.
For information about running the diagnostic procedure, refer to "Service Library: Key Path Diagnostics"
on page 155.

Restoring factory default settings

About this task
If you want to erase your current configuration and restore factory default settings, do so by selecting
Restore Factory Defaults in the Configure Library > Save/Restore menu. See "Configure Library:
Save/Restore" on page 150.
The factory default settings are listed in Table 26 on page 106.

Logging out of the Web User Interface

To log out of the Web User Interface, click Logout in the upper right corner of the screen.
Important: If you click the X in the upper right corner of your internet browser window, you do not log
out of the Web User Interface.

Configuring your library with the Operator Control Panel

If you choose to use the Operator Control Panel for configuring your library, go to "Configure menu" on
page 98 for information about configuring the following items:
v Logical libraries
v Library settings
v Drives
v Network
v Set access PIN
v Set date and time
v Path failover
Note: IPSec configuration is limited to the Web User Interface.
To complete the configuration of your library, the following items must be accessed from the Web User
Interface:
v Encryption (see "Configure Library: Encryption" on page 125)
v User access information (see "Configure Library: User Access" on page 145)
73
Installation and configuration