IBM TS3100 Setup, Operator, And Service Manual page 240

Table 54. Warning events (continued)
49 SCSI: incompatible magazine, magazine
not accessible
4A SCSI: source not ready
4B SCSI: destination source not ready
4C SCSI: library controller busy
4D SCSI: Cannot make reservation
4E SCSI: invalid slave robotic controller
request
4F SCSI: robotic axes/motors aren't
initialized
50 SCSI: cartridge belongs to another
partition
51 Incompatible medium
52 All slots full, no movement possible
53 All slots empty required for wellness test Fill up required slots before the wellness test is started.
54 SCSI: failure in LME interface
55 SCSI: invalid license key entered
58 Recovered Error: SCSI parity error
59 Recovered Error: Error log overflow
5A Illegal request, downgrade prohibited
5B Incompatible medium generation
5C Illegal request, downgrade that is
prohibited because of incompatible
network stack
5D Illegal request, wrong drive FW for drive Obtain correct drive firmware image.
5E Full height drive in illegal position
60 Cleaning cartridge installed
61 Cleaning failure. Cleaning process could
not be performed
62 Cleaning cartridge expired
63 Invalid cartridge. Drive rejected the data
cartridge as invalid
64 Invalid cleaning cartridge. Drive rejected
the cleaning cartridge as invalid
65 Invalid upgrade cartridge. Drive rejected
the upgrade cartridge as invalid
66 Medium error; diagnostic tape write
protected
212
IBM TS3100 Tape Library and TS3200 Tape Library: Setup, Operator, and Service Guide Machine Type 3573
Check your configuration settings.
Complete move process and retry operation.
Complete process and retry operation.
Refer to your host application documentation for problem
determination information.
Check robotics status. Refer to "Isolating a library controller
card versus accessor enclosure problem" on page 197.
Check application software.
Check the compatibility of media and drive generation.
Remove a cartridge to make a move possible.
1. Check your Encryption configuration.
2. Run Key Path Diagnostics.
3. Refer to your EKM server documentation.
Reenter license key. If problem persists, refer to "Contacting
IBM technical support" on page 219.
No user action is required.
Disable encryption for firmware downgrade.
Replace incorrect cartridges.
Change network settings to IPv4 only before downgrading
firmware.
Check correct Drive position.
Complete the cleaning process and retry the operation.
1. Verify that autoclean is enabled.
2. Check for an expired cleaning cartridge and replace if
necessary.
3. Refer to "Configuring I/O stations and reserving slots"
on page 160.
Replace cleaning cartridge.
1. Verify that the correct cartridge is being used. Refer to
"Cartridge compatibility" on page 165.
2. Refer to "Identifying a suspect cartridge" on page 199.
Not supported
Ensure that diagnostic tape is not write protected.