Configure: Network; Configure: Network Menu - IBM TS3100 Setup, Operator, And Service Manual

Configure: Network

DHCP-ON
Figure 78. Configure: Network menu
Use these menu items to change the current network settings, which access the library remotely by way
of a web browser.
v IP Stack - Choose IPv4 only, IPv6 only, or IPv4 & IPv6.
v IPv6 Only and Dual Stack IPv4 & IPv6 - Choose Enable Stateless Auto Config Address (Web User
Interface) or Stateless Autoconfig (Operator Control Panel) if assigned IPv6 IP addresses are wanted. To
view the assigned IPv6 addresses after Stateless Auto Config Address is enabled:
– Operator Control Panel (IPv6 Only): Monitor > Library > Network
If you choose Dual Stack IPv4 & IPv6, you must be prepared to enter both IPv4 and IPv6 IP
addresses.
v DHCP - (Dynamic Host Configuration Protocol) If DHCP is enabled, your library host negotiates the
connection with the library. If DHCP is disabled, the following information is necessary to establish the
remote access.
v IP Address - the IP address of the library
v Netmask - the Network Mask address of the library
Configure
Network
IP Stack
DHCP-OFF
(IPv4 & IPv4+IPv6)
IP Address
Netmask
Gateway
Ethernet
DHCP-OFF
(IPv6)
Stateless
autoconfig
Prefix Length
Static IPv6
Address
Gateway
Ethernet
Operations
103