Ending Procedure; Accessing The Library With Telnet - IBM TS3100 Setup, Operator, And Service Manual

Ending procedure

Procedure
1. Reassemble the drive brick by reversing the steps in "Removing the drive cover" on page 264.
2. Reassemble the drive sled by completing these steps:
a. Reinstall the drive brick into the sled by completing these steps:
v Plug in the RS-422 cable, the power cable (if applicable), and the signal cable.
v Push the drive brick fully into the sled.
v Align the two screws holes on each side of the sled with the screw holes on each side of the
drive brick. DO NOT TIGHTEN THE SCREWS COMPLETELY.
v After verifying that the drive and sled are properly aligned, fully tighten the screws.
b. If necessary, complete these steps to reinstall the connection card and protective plastic cover on
the sled.
v Place the card and the protective plastic cover on top of spacers that align the three screw holes.
DO NOT TIGHTEN THE SCREWS COMPLETELY.
v After verifying that the connection card and protective plastic cover are properly aligned, fully
tighten the three screws.
3. Install the tape drive sled in the library. Refer to "Installing a tape drive sled" on page 226.
4. Power ON the library and wait for the library to finish POST (power on self test), inventory, and
mid-tape recovery (this step can take up to 1 hour).
5. If the cartridge does not eject from the drive, move the cartridge from the drive to the I/O Station
(Operator Control Panel: Control > Move Cartridges; Web User Interface: Manage Library > Move
Media), then discard the cartridge.
6. Run Library Verify before normal library operations resume. Refer to "Service: Library Verify" on
page 108.
7. If necessary, return the failed drive sled to IBM.

Accessing the library with Telnet

To access a customer's library with telnet, complete the following procedure:
1. Ask the library administrator to enable the serial port (Operator Control Panel: Service > Telnet
Service Port).
2. Open a Windows Command Prompt screen.
3. Enter telnet [library IP address] then press the Enter key.
4. FLMON> displays.
5. Enter lgi, then press the Enter key.
6. Enter service as your user name, then press the Enter key.
7. Enter the service Password, then press the Enter key. Contact your next level of support for the
password.
8. Enter help, then press the Enter key for the expanded command menu.
9. To end the telnet session, enter lgo, then press the Enter key to log out of the library.
10. Enter exit, then press the Enter key to disconnect from the library.
11. Inform the library administrator that your telnet session ended and instruct the administrator to
reboot the library to disable telnet capabilities to the library.
Appendix A. Information for trained service personnel
283