Right Deck And Components; Typical Deck Structure Mounting - Komatsu 930E-2 Shop Manual

(NOTE: Bottom, RH deck shown. LH deck mounting is similar to RH deck)
1. Deck Structure
2. Deck Mounting Location
3. Payload Indicator Lights
4. Clearance Light
DECKS
The right and left deck mounting pad locations are
nearly identical. The decks are mounted directly to the
frame support structures using hardened flatwashers.
Be certain to use hardened flatwashers during reas-
sembly.

RIGHT DECK AND COMPONENTS

Removal
1. Shut down engine following all the procedures
listed on page 2-1 of this Section of the manual.
2. Remove access covers from retarding grid assem-
bly. Tag and disconnect all electrical leads in
preparation for removal. Attach lifting device to
grid lifting eyes.
3. Remove grid assembly mounting hardware at four
locations (6) shown in Figure 2-3.
B02015
FIGURE 2-3. TYPICAL DECK STRUCTURE MOUNTING
Structural Components
5. Headlights
6. Retard Grid Mounting Location
7. Electrical Connector
4. Lift grid assembly clear of deck structure and move
to a work area.
NOTE: If grid assembly or cooling blower repairs are
required refer to applicable G.E. publication for serv-
ice and maintenance procedures.
5. Disconnect electrical harness at connector (7,
Figure 2-3). Inspect underside of deck and if nec-
essary, remove any hoses or cables that remain.
(Light harness and clamps do not require re-
moval.)
6. Install lifting device at eyes at each corner of the
deck and take up slack. Do not attach lifting
device to the hand rail structure.
7. Remove deck mounting hardware at deck support
and front upright (2).
8. Verify all wiring harnesses, cables or hoses have
been removed. Carefully raise deck and remove
from deck supports.
B2-3