RETARDER CONTROL LEVER (STEERING COLUMN-MOUNTED)
Due to wear, the Retarder Control Lever assembly (4,
Figure 3-30) may occaionally require adjustment or
repair.
Lever Assembly Removal
Adjustment of the lever assembly or replacement of
the potentiometer requires removal of the assmbly
from the steering column.
1. In the operator cab, remove the capscrews (1,
Figure 3-30) and lockwashers (2) from steering
column (3).
2. Disconnect harness connecter (5) from lever as-
sembly (4).
FIGURE 3-30. COLUMN-MOUNTED RETARDER CONTROL LEVER
1. Capscrew, Socket Hd.
2. Lockwasher
3. Steering Column Assy. 7. Lockwasher
4. Retarder Control Assy.
J3-30
5. Harness Connector
6. Capscrew, Socket Hd.
8. Potentiometer (Switch Assy.) 12. Washer, Internal Tang 16. Handle
Brake Circuit Component Service
Lever Assembly Installation
1. Connect harness connecter (5, Figure 3-30) to
lever assembly (4).
Install lever assembly to steering column (3).
2. Install capscrews (1) and lockwashers (2).
Tighten socket head capscrews to 36 in. lbs. (4.1
N.m) torque.
9. Locknut
10. Washer, Tanged
11. Spring, Disc
13. Bracket
14. Shaft
15. Lever
J03019 1/99