Setup And Maintenance; Speed Limit; Setting The Speed Limit; Setting The Option Code - Komatsu 930E-2 Shop Manual

SETUP AND MAINTENANCE

Speed Limit

A warning can be displayed if the machine exceeds a
preset speed.
The available range is: 10 - 99 km/h (6 - 62 mph). It is
recommended to set the speed limit to 99 km/h (62
mph).

Setting The Speed Limit

1. Press and hold the MODE switch
until "Cd:dP" is flashing.
2. Press the MODE switch once.
The display will show:
3. Press the MODE switch once.
The display will show:
4. Press the MODE switch repeatedly
until "SP.XX" is displayed.
5. Press the LIGHT/INC switch to change the "unit
digit" to the desired number.
6. Press the TOTAL/SFT switch
and the display will then indicate:
7. Press the LIGHT/INC switch to change the "tens
digit" to the desired number.
8.Press the MODE switch to return to normal opera-
tion.

Setting the Option Code

1. Press and hold the MODE switch
until "Cd:dP" is displayed.
2. Press the MODE switch once.
The display will show:
3. Press the MODE switch once.
The display will show:
4. Press the MODE switch repeatedly
until "OP.XX" is displayed.
5. Press the LIGHT/INC switch to change the "unit
digit" to the desired number.
6. Press the TOTAL/SFT switch
and the display will then indicate:
M20007 10/00
7. Press the LIGHT/INC switch to change the "tens
digit" to the desired number.
8.Press the MODE switch to return to normal opera-
tion.
9. The Option Code selects the PLM communication
mode as follows:
Option
Code
0 Stand Alone
10 PMC Mode (530M only)
Modular Mining Mode, Scoreboard
12
and User Data Commmunication Mode
NOTES:
1. The Option Code is set to "0" for trucks not
equipped with Modular Mining System (MMS)
(Except 530M).
2. The 530M with Powertrain Management Control
(PMC) system uses "10" as the setting for the
Option Code.
3. For trucks with Modular Mining System (MMS) or
Scoreboard, the Option Code is "12".
Setting The Machine I.D. Code
1. Press and hold the MODE switch
until "Cd:dP" is displayed.
2. Press the MODE switch once.
The display will show:
3. Press the MODE switch once.
The display will show:
4. Press the MODE switch once.
"d.XXX" is displayed.
5. Press the LIGHT/INC switch to change the last
digit to the desired number.
6. Press the TOTAL/SFT switch
and the display will show:
7. Press the LIGHT/INC switch to change the middle
digit to the desired number.
8. Press the TOTAL/SFT switch
and the display will show:
Payload Meter II
COMMUNICATION MODE
M20-17