Table of Contents
Advertisement
HOIST CONTROL LEVER
The hoist control (3, Figure 5-4) is a four position
hand-operated lever located between the operator
seat and the Center Console (see illustration below).
To Raise dump body:
1. Pull the lever to the rear to actuate hoist circuit.
(Releasing the lever anywhere during "hoist up"
will place the body in "hold" at that position.)
2. Raise engine RPM to increase hoist speed.
3. Reduce engine RPM as the last stage of the hoist
cylinders begin to extend and then let the engine
go to low idle as the last stage reaches half-ex-
tension.
4. Release hoist lever as the last stage reaches full
extension.
5. After material being dumped clears the body,
lower the body to frame.
Refer to "OPERATING INSTRUCTIONS, DUMPING",
Section 3, of the Operation and Maintenance Manual
for more complete details concerning this control
To lower body:
Move hoist lever forward to "down" position and re-
lease. Releasing the lever places hoist control valve in
the "float" position allowing the body to return to frame.
N5-8
ASH TRAY
The Ash Tray(4, Figure 5-4) is used for extinguishing
and depositing smoking materials. DO NOT use for
flammable materials, such as paper wrappers, etc.
Be certain that all fire ash is extinguished!
LIGHTER
The LIGHTER (5, Figure 5-4) may be used for lighting
cigars/cigarettes.
Always use CAUTION with smoking materials!.
This socket may also be used for a 12 VDC power
supply.
L.H. WINDOW CONTROL SWITCH
This switch (6, Figure 5-4) is spring-loaded to the
"OFF" position.
Pushing the front of the switch raises the left side
cab window.
Pushing the rear of the switch lowers the window.
R.H. WINDOW CONTROL SWITCH
This switch (7, Figure 5-4) is spring-loaded to the
"OFF" position.
Pushing the front of the switch raises the right side
cab window.
Pushing the rear of the switch lowers the window.
ENGINE SHUTDOWN SWITCH
This switch (8, Figure 5-4) is used for engine
shutdown by depressing this button and
holding it until engine stops.
Use this switch to shutdown engine if en-
gine does not shutdown by turning off keyswitch, or to
shutdown engine without turning off 24 VDC electric
circuits.
There is also a ground level engine shutdown switch
on the left front frame rail behind the ladder.
Operator Cab Controls
N05044
Advertisement
Table of Contents
Troubleshooting
