9. WHEELS AND TIRES -
a. Inspect tires for proper inflation and wear.
b. Inspect for debris embedded in cuts or tread.
c. Inspect for damaged, loose, or missing wheel
mounting nuts or studs.
12. BODY-UP SWITCH (Not Shown) -
Clean sensing area of any dirt accumulation and
check that wiring is intact.
13. CAB AIR FILTER (Not Shown) - Under normal
operating conditions, clean every 250 hours. In
extremely dusty conditions, service as frequently
as required. Clean filter element with mild soap
and water, rinse completely clean and air dry with
maximum of 40 psi (275 kPa). Reinstall filter.
14. AUTOMATIC LUBE SYSTEM -
a. Check grease reservoir; fill as required.
Lube Key "D".
b. Inspect system and check for proper operation.
Be certain the following important areas are
receiving adequate amounts of grease. Lube
Key "D".
Steering Linkage -
Final Drive Pivot Pin -
®
Rear Hydrair
Suspension Pin Joints -
Body Hinge Pins -
Hoist Cylinders Pins - Upper & Lower
Anti-sway Bar - Both Ends
15. COOLING AIR DUCTWORK -
Inspect ductwork from blower to rear drive case to
be certain that ductwork is secure and undamaged
and there are no cooling air restrictions.
P02034
10 HOUR (DAILY) INSPECTION
(continued)
Upper & Lower
Lubrication and Service
√'d
COMMENTS
INITIALS
P2-5