Center Console; F-N-R Selector Switch - Komatsu 930E-2 Shop Manual

CENTER CONSOLE

The Center Console (1, Figure 5-4) contains:
(1) Center Console

(2) F-N-R Selector Switch

(3) Hoist Control Lever
(4) Ash Tray
(5) Cigar/Cigarette Lighter
(6) L.H. Window Control Switch
(7) R.H. Window Control Switch
(8) Engine Shutdown Switch
(9) Override/Fault Reset Switch
(10) BLANK - NOT USED on this truck
(11) RSC "Off/On" Switch
(12) Retarder Speed Control Dial
(13) Propulsion System Controller (PSC)
Diagnostic Port
(14) Engine Diagnostic Port (3 Pin)
(15) Truck Control Interface (TCI)
Diagnostic Port
(16) Passenger Seat
(mounted on top of the right hand
portion of the Console structure)
(17) Engine Diagnostic Port (9 Pin)
F-N-R SELECTOR SWITCH
The Selector Switch (2, Figure 5-4) is mounted on a
console to the right of the operator's seat. It is a three
position switch which controls the Forward-Neutral-
Reverse motion of the truck. When the Selector Switch
handle is in the center "N" position, it is in "Neutral".
The handle must be in Neutral to start the engine.
The operator can select Forward drive by
moving the handle forward.
Reverse drive can be selected by moving
the handle to the rear.
The truck should be stopped before the selector
handle is moved to a drive position.
N05044
FIGURE 5-4. CENTER CONSOLE
Operator Cab Controls N5-7