Psc Programming; Inverter Programming; To Program The 17Fb147 Cpu Card; To Program The Inverters - Komatsu 930E-2 Shop Manual

PSC PROGRAMMING

NOTE: At the present time, GE or KMS PERSON-
NEL must be present to program the PSC.
BE SURE TO VERIFY LINK VOLTAGE IS DIS-
CHARGED BEFORE PERFORMING THE FOLLOW-
ING PROCEDURES.
1. Disconnect Circuits 21SS and 21SR and insulate
from engine starter if equipped with MTU 396
engine. If MTU/DDC 16V4000 or Komatsu engine
is installed, disconnect and insulate circuit 21B at
the starter solenoids. Apply park brake and brake
lock.
a. Connect the serial communication cable from
the PTU to the PSC port located behind the
center console in the cab on the operator's
side.
b. Be certain the Rest Switch in the cab is in the
REST position.
2. Turn the Key Switch ON.

To program the 17FB147 CPU card:

¤ c:\>ACNMENU {enter}
¤ Highlight "DOWNLOAD PSC PANEL" {enter}
¤ Highlight "SELECT PSC SETUP"
¤ Cursor to the appropriate configuration file for the
truck being programmed from the list of configu-
ration files {enter}
¤ Highlight "DOWNLOAD PSC PANEL"
¤ Highlight "DOWNLOAD PSC"
3. Cycle keyswitch or CPS when requested on
screen.
4. Verify the Object Code and Configuration file
shown on the screen for downloading is correct.
E03015 3/01 AC Drive System Electrical Checkout Procedure
(Release 17 Software)

INVERTER PROGRAMMING

NOTE: At the present time, GE or KMS PERSON-
NEL must be present to program the PSC.
BE SURE TO VERIFY LINK VOLTAGE IS DIS-
CHARGED AND ENGINE IS NOT RUNNING BE-
FO R E P E RFO R MI NG
PROCEDURES.
1. Open the right door on the Electrical Control
Cabinet and connect the serial communication
cable from the PTU to one of the two ports located
to the right of the PSC Panel. (RS11 is used for
the inverter card in slot No. 09, RS12 is used for
the inverter card in slot No. 11.)

To program the Inverters:

¤ c:\>ACNMENU {enter}
¤ Highlight "DOWNLOAD INVERTERS" {enter}
¤ Highlight either "DOWNLOAD TMC (17FB172)
or "DOWNLOAD IMC (17FB138)", depending on
which cards are installed in slots No. 09 and 11.
{enter}.
2. Cycle keyswitch or CPS when requested on
screen.
3. Verify the file shown on the screen for download-
ing is correct.
TH E FO LLOW ING
E3-11