Key Information - SpectraLink NetLink e340 Configuration And Administration Manual

SpectraLink Corporation
Learn Always
on or loss of contact with the wireless LAN (out of range). This may be useful if
the handset will be used at more than one site.
: If your access points do not accept broadcast ESSID or if there are
Static Entry
overlapping wireless systems in use at the site, enter the correct ESSID manually.
Security
Security
disables any 802.11 encryption or security authentication mechanisms.
*NONE
For WEP, WPA-PSK and WPA2 PSK set each of the following options to
match exactly the settings in your APs.
Encryption codes display as they are entered. For security reasons codes
will not display when a user returns to the Admin menu, Encryption
options.
(Wired Equivalent Privacy) is a wireless encryption protocol that encrypts data
WEP
frames on the wireless medium allowing for greater security in the wireless network.
If WEP is required at this site, you must configure each handset to correspond with
the encryption protocol set up in the access points. Select the entries from the
options below to enable the handset to acquire the system.
Authentication
Select either
WEP On/Off
Select either

Key Information

Default Key
through
Key Length
specified for use at this location.
Key 1-4
entered above. Enter the encryption key as a sequence of hexadecimal
characters. (Use the 2 and 3 keys to access hexadecimal digits A-F, use the
Right Arrow key to advance to the next digit, and the Left Arrow key to
backspace.) For 40-bit keys you will need to enter 10 digits, for 128-bit keys
you will need to enter 26 digits. The display will scroll as needed.
Rotation Secret:
custom document if this feature is supported in your system.
(Fast Secure Roaming) In order to provide the highest level of security
Cisco FSR
without compromising voice quality on Cisco Aironet wireless LAN access points,
SpectraLink and Cisco Systems have cooperated to implement the Fast Secure
Roaming mechanism. FSR is designed to minimize call interruptions for NetLink
Wireless Telephone users as they roam throughout a facility. Existing Aironet 350,
1100, and 1200 APs may require a firmware upgrade to support FSR. Cisco FSR
requires advanced configuration of the Cisco access points in your site. See your
PN: 72-1084-02-E.doc
Configuration and Administration—NetLink e340/i640 Wireless Telephone
: Allows the handset to automatically learn the ESSID at each power
or
Open System Shared Key
or .
WEP Off WEP On
: Enter the key # specified for use by the handsets. This will be
.
4
: Select either -
40 bit
: Scroll to the key option that corresponds to the
This is used for proprietary WEP key rotation. Refer to your
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
.
or - depending on the key length
128 bit
1
that was
Default Key
Page 22