Handset Modes - SpectraLink NetLink e340 Configuration And Administration Manual

SpectraLink Corporation
3.4

Handset Modes

Standby (on-hook)
In the standby mode the handset is waiting for an incoming call or for the user to
place an outgoing call. The extension number is shown on the display and there is no
dial tone. In this mode, the handset is conserving battery power and wireless LAN
bandwidth.
When an incoming call occurs the handset will ring until the call is answered by
pressing the
Start Call
Predial
To place a call using predialing (cell phone dialing), dial the number while in standby
mode and then press
and the number is immediately called.
Active (off-hook)
To place a call, press the
active off-hook mode. There is a dial tone, the Wireless Telephone is in
communication with the PBX, and the display shows information as it is received
from the PBX. The user may place a call or press the
operations.
The Wireless Telephone is also in the active mode when a call is received.
When an incoming call occurs during an active call the handset will play the second
line ringing sound until the call is answered, the caller hangs up, or the call transfers
to voicemail. If
to a full ring.
The active modes utilize the most bandwidth and battery power. To conserve these
resources, return the handset to the standby mode when a call is completed by
pressing the
End Call
Active (on-hook)
To transition from the standby mode to the active on-hook mode, press the
key. In this mode, the handset displays the text display as seen on an idle 5220 IP
phone, usually the date and time. There is no dial tone. The user may press the
or key to access all operations available from the active off-hook mode.
LINE
When an incoming call occurs the handset will ring loudly until the call is answered
or the
End Call
second-line ringing sound.
If there is no activity for 45 seconds, to conserve bandwidth and battery power the
handset will return to the standby mode.
PN: 72-1084-02-E.doc
Configuration and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
key or the
End Call
This transitions the handset to active off-hook mode
Start Call.
key. This transitions the Wireless Telephone to
Start Call
is pressed, the first call is terminated and the handset reverts
End Call
key.
key is pressed. If an active key is pressed, the ring will convert to the
key is pressed to silence the ringing.
or
FCN LINE
key to access
MENU
FCN
Page 14