No representation or other affirmation of fact contained in this document including but not limited to statements regarding capacity, response-time performance, suitability for use, or performance of products described herein shall be deemed to be a warranty by SpectraLink for any purpose, or give rise to any liability of SpectraLink whatsoever.
Page 3
Telephone Switch Interface Matrix (72-0070-10). Available at http://www.spectralink.com/consumer/resources/interface_guides.jsp. Contacting SpectraLink SpectraLink wants you to have a successful installation. If you have questions please contact our Customer Support Hotline at (800) 775-5330. The hotline is open Monday through Friday, 6:00 a.m. to 6:00 p.m. Mountain time.
Page 4
This manual uses the following icons and conventions. Caution! Follow these instructions carefully to avoid danger. Note these instructions carefully. NORM This typeface indicates a key, label, or button on SpectraLink hardware. Part Number: 72-0171-10-C.doc LinkPlus Interface Guide Mitel SX-50, -200, -2000 System...
See Link 3000 MCU: Operator’s Console, Link 150 M3 MCU: Installation and Operation, or NetLink Telephony Gateway: Installation, Configuration, and Administration. The following information will help the system administrator set up the SpectraLink Wireless Telephones to operate in a way that feels familiar and comfortable to users. Plan Programming...
The SpectraLink Wireless Telephone Display The Link Wireless Telephone has a two-line, 16-character alphanumeric display. Certain characters may be used by the system that are not implemented in the handset.
Page 7
Link 3000 MCU Note that the function menu defaults set for the handsets associated with the Link 3000 MCU can be changed via the SpectraLink Operator’s Console. If the system uses softkeys, to minimize unwanted interaction between system display and the handset function menu display, configure the handset menu to include a delay of one function key.
Page 8
Delay (same as the Link 3000 MCU).See NetLink Telephony Gateway: Installation, Configuration, and Administration for the NetLink for further details. Also refer to the same document for details on configuring the telephone switch type...
Interface Implementation This section describes the recommended programming to use the Wireless Telephone System (CPM interface module or SCX-416 MCU) with a Mitel PBX. The procedures assume: • The Mitel SX-200, SX-50, or SX-2000 system is installed and operational in an approved configuration.
Page 10
SpectraLink Corporation Key-mapping the Handset to Emulate the Superset 420 [number] and LINE handset mapped to the corresponding key on the desk set. The handset function menu default settings are shown in the table below; these may be changed as described above in Function Menu Programming.
Page 11
SpectraLink Corporation Program Mitel The Mitel Technician should perform the necessary customer data entry, through an ASCII administration terminal or through the attendant console. • Use Form 09 to program each handset as station type 420. • Program the keys (line and call appearances and features) according to the pre- installation planning.
Need help?
Do you have a question about the NetLink e340 and is the answer not in the manual?
Questions and answers