Tektronix AWG5200 Series Technical Reference page 44

Brief procedures
32
6. Click the Reset to Default Setup button in the toolbar
7. From the Waveform List window, assign the waveform PV_Square.wfmx to
the channel under test.
8. In the Setup tab, enable the channel's output.
9. Press the All Outputs Off button on the generator (toggle from red to green)
to enable all outputs.
10. Click the Play button on-screen or press the button on the front panel of the
generator.
11. Check that the channel waveform is properly displayed on the test oscilloscope
screen.
12. Press the All Outputs Off button on the generator (toggle from green to red)
to disable all outputs.
13. Repeat the test for each generator channel.
14. Disconnect the test setup.
.
AWG5200 Series Technical Reference