Advertisement
CLOCK (fig. 76)
Adjusting the hours
Press the MODE button in
will flash. Set the hour required using button
â
ã
or
.
Every press on the button will increase
by one unit.
Keeping the button pressed obtains auto-
matic fast increase or decrease.
When you are near the value required,
release the control and complete adjust-
ment with single presses.
Then press the MODE button in
store.
clock and outside temperature display
58
fig. 76
Adjusting the minutes
Press the MODE button twice in
the minutes will flash. Set the minutes
Q
, the hours
required using button
Every press on the button will increase
by one unit.
Keeping the button pressed obtains auto-
matic fast increase or decrease.
When you are near the value required,
release the control and complete adjust-
ment with single presses.
Then press the MODE button in
store.
R
to
OUTSIDE TEMPERATURE (fig. 76)
Outside temperature can be viewed on
the display lower side, under the hour indi-
cation. When the outside temperature is
below or 3° C, the indicator starts flashing
together with the buzzer, to warn the dri-
A0A0009b
ver about the possible presence of ice on
the road. The acoustic signal lasts about 2
seconds, while the outside temperature
indicator flashes for about 10 seconds.
The signal of possible presence of ice on
the road is repeated only if the outside
temperature is over 6° C and then reach-
es again 3° C.
BUZZER (fig. 77-78)
Q
,
The buzzer which accompanies the con-
trols may be activated (
â
ã
or
.
ed (
Press the MODE button 3 times in
then use button
buzzer on or off.
The press the MODE button in
store the condition chosen.
R
to
buzzer activated display (
fig. 77
) or deactivat-
ON
); proceed as follows:
OFF
â
ã
or
, to turn the
R
)
ON
Q
,
to
A0A0083b
Advertisement
