Advertisement
ENGINE OIL (fig. 4-4a-5-6)
The engine oil should be checked with
the vehicle on a level surface a few min-
utes (about 5) after the engine has been
switched off.
Remove the dipstick (A), clean it, put it
back in completely, remove it and check
that the level is within the MIN and
MAX marks on the dipstick. The interval
between the MIN and MAX marks cor-
respond to about one litre of oil.
Do not add oil with spec-
ifications (classification,
viscosity)
other
those of the oil already in the
engine.
fig. 4 - 1.8 T. SPARK version
When the engine is hot,
take care when working
inside the engine com-
partment
to
Remember that when the engine
is hot, the fan may cut in: danger
of injury.
than
fig. 4a - 2.0 JTS version
A0A0737b
A
fig. 5 - 3.2
version
V6
If the oil level is near or even below the
MIN mark, add oil through the filter neck
(B), until reaching the MAX mark.
avoid
burns.
IMPORTANT If a routine check
reveals that the level is above the MAX
mark, contact Alfa Romeo Authorised
Services to have the correct level restored.
IMPORTANT After topping up the oil,
before checking the level again, run the
engine a few seconds and wait for a few
minutes ater stopping it.
A0A0682b
A0A0406b
B
fig. 6 - JTD
A0A0398b
version
16V
255
Advertisement
