Advertisement
Total extension
Proceed as follows:
– check that seat buckles of the side
belts are fitted in the respective pockets
on the back rest (A-fig. 20) and the tab
(B) of the centre abdominal belt is insert-
ed in the support (C).
– pull the handles in the centre of the
cushions, then tilt them forwards;
20
fig. 20
– raise the headrest to the highest posi-
tion, press both buttons (A-fig. 21) at
the side of the two supports, then remove
the headrest pulling them upwards;
– move the seat belts to the side
extending them correctly without twisting;
– raise the levers (A-fig. 22) retain-
ing the back rests and tilt them forwards
to obtain a single loading surface
(fig. 23).
A0A0623b
fig. 21
IMPORTANT For versions/markets
where applicable, the retainer levers are
replaced by buttons (one for each side).
To release the back rests and tilt them,
use the buttons themselves.
fig. 22
A0A0607b
fig. 23
A0A0608 b
A0A0608 b
Advertisement
