Table of Contents
Advertisement
Test Report No.: No.: 17706687 001
Part II of II
Requirement Test
Clause
7.6
Addition: The direction of rotation of the saw blade
shall be indicated on a fixed part of the tool in the
vicinity of the spindle axis by an arrow raised or
sunk, which is visible when changing the saw
blade, or by any other means not less visible and
indelible.
The following instructions shall also be given:
7.13
c)
Z101)
Z102)
Page 49 of 63
EN 61029-2-1:2012
Safety precautions
Do not use saw blades which are,
-
damaged or deformed;
Replace table insert when worn;
-
Use only saw blades recommended
-
by the manufacturer, which conform
to EN 847-1, with a warning that the
riving knife shall not be thicker than
the width of the groove cut by the saw
blade and not thinner than the body of
the saw blade;
-
Take care that the selection of the
saw blade is suitable for the material
to be cut;
Wear suitable personal protective
-
equipment when necessary, this
could include
1) hearing protection to reduce the risk of
induced hearing loss,
2) respiratory protection to reduce the risk
of inhalation of harmful dust,
3) wear gloves when handling saw blades
and rough material, saw blades shall
be carried in a holder whenever
practicable;
-
Connect circular saws to a dust-
collecting device when sawing wood.
The operator shall be informed of the
factors that influence exposure of
dust e.g. type of material being
machined and importance of local
extraction (capture or source) and
proper adjustment of
hoods/baffles/chutes;
Do not use High speed steel (HS)
-
blades;
-
The push-stick or push block should
always be stored with the machine
when not in use.
warning not to use saw blades which are
damaged or deformed;
instruction to replace table insert when
worn;
Result - Remark
Provided on the saw blade
fixed guard under table by a
raised arrow.
All information is provided
and found satisfactory.
Verdict
P
P
Advertisement
Chapters
Table of Contents
