Table of Contents
Advertisement
6.17 Table insert
See Figure 6-14.
1.
Remove blade guard and riving knife.
2.
Lower blade completely.
3.
Place table insert into opening with notched
end towards rear of table, as shown.
4.
Adjust insert flush with table by turning four
leveling setscrews (L) and using a straight
edge at different points over the insert. A
2.5mm hex key is required to adjust the
setscrews.
5.
Turn lock knob (M) so that it catches insert and
holds it against table. If lock knob will not catch
properly, remove insert and adjust spring
tension by turning the nut on the knobs' shaft.
Figure 6-14
6.18 Miter gauge
See Figure 6-15.
Figure 6-15
Operate miter gauge by loosening lock knob (A)
and turning miter body (B) to desired angle.
The pin (C) functions as an index stop. When
pushed in, the body will stop at -45º, 90º or +45º
when turned, as one of three screws (D) located
underneath the miter body hits the pin.
You can adjust any play of the miter gauge in the
table slot by tightening set screws (E).
Calibration
If a miter angle at the -45º, 90º or +45º is not
correct, the index stops can be adjusted by turning
one of three adjustment screws (D), then tightening
the hex nut.
Note: Always make test cuts. Do not rely solely on
miter gauge indicator marks.
6.19 Tool storage
The fence assembly can be stored on the motor
cover hooks. Arbor wrench and low profile riving
knife are stored on tool holder on right side of saw.
Below tool holder is a hook for accessory storage.
Install the additional hook (HP1) to any surface of
saw stand with the tapping screws (HP10). Drill
pilot holes before inserting screws.
7.0 Electrical connections
The JPS2-115 table saw is wired for 120-volt only.
The JPS2-230 is wired for 230-volt only. The table
saw comes with a plug designed for use on a
circuit with a grounded outlet that looks like the one
pictured in either A or D, Figure 7-1.
Before connecting to power source, be sure switch
is in off position.
It is recommended that the JPS2 table saw be
connected to a dedicated 15 amp circuit with circuit
breaker or fuse. If fuses are used, they should be
time-delay fuse marked "D".
NOTE: Local codes take precedence over
recommendations.
7.1 GROUNDING INSTRUCTIONS
1. All Grounded, Cord-connected Tools:
This machine must be grounded. In the event of a
malfunction or breakdown, grounding provides a
path of least resistance for electric current to
reduce the risk of electric shock. This tool is
equipped
with
an
equipment-grounding conductor and a grounding
plug. The plug must be plugged into a matching
outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
Do not modify the plug provided - if it will not fit the
outlet, have the proper outlet installed by a
qualified electrician.
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. The
conductor with insulation having an outer surface
that is green with or without yellow stripes is the
equipment-grounding
replacement of the electric cord or plug is
necessary,
do
not
grounding conductor to a live terminal.
16
electric
cord
having
conductor.
If
repair
connect
the
equipment-
an
or
Hide quick links:
Advertisement
Table of Contents
