Jet JTS-315LA Operating Instructions Manual page 77

Test Report No.: No.: 17706687 001
Part II of II
Requirement  Test
Clause
Screws and nuts
Soldered connection for input <100W
24.2 Cross-sectional area of conductors of terminals for
type X attachment
24.3 Terminals and termination for type M attachment
Pull test for terminal and termination .......................:
24.4 Fixing of terminals
Testing terminal connection .....................................:
24.5 Contact pressure and prevention of the damaging
to the conductor
24.6 Terminals of tools having a rated current < 16A
24.7 Pillar type terminals
Dimension according to table 11
Length of the thread part
Sharp indentations or projections at the surface
Visibility of conductor beyond the threaded hole
24.8 Screw type terminals
Dimensions according to table 12
Length of thread in terminal screw hole obtained by
plunging
Use of intermediate parts
Reduction of head of the screw
Locking of intermidiate parts against rotation
Screw dimension for intermidiate parts with more
than one screw
24.9 Stud type terminals
Dimension according table 13
24.10 Length of thread in pillar, screw, hole or nut or the
length of the thread on the screw smaller than
specified in table 13
Test for above screws and nuts ...............................:
Damaging and impairing of terminal
Moving of conductor in the terminal
Page 37 of 63
EN 61029-1:2009+A11
Result - Remark
user, no terminals provided for
external conductors on this
machine.
Verdict
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A