Wheel - Jet JTS-315LA Operating Instructions Manual

Test Report No.: No.: 17706687 001
Part II of II
Requirement  Test
Clause
20.21 Circular saw benches are machines where a
considerable amount of dust may be expected to
be produced.
20.Z101 Circular saw benches shall be provided with
effective lifting and transportation positions, which
are identified clearly on the machine and in the
instructions.
20.Z102 Circular saw benches shall be provided with
provision to store the push-stick or push block
handle on the machine when not in use
20.Z103 Saw blades delivered with the machine shall
comply with EN847-1.
Compliance with 20.Z101 to 20.1103 is checked
by receipt of relevant information of the
manufacturer or by measurement.
Internal wiring
21
This clause of Part I is applicable.
Components
22
This clause of Part I is applicable.
Supply connection and external flexible cables and cords
23
This clause of Part I is applicable.
Terminals for external conductor
24
This clause of Part I is applicable.
Provision for earthing
25
This clause of Part I is applicable.
Screws and connections
26
This clause of Part I is applicable.
Creepage distances, clearances and distances through insulation
27
This clause of Part I is applicable.
Resistance to heat, fire and tracking
28
This clause of Part I is applicable.
Resistance to rusting
29
This clause of Part I is applicable.
Radiation
30
This clause of Part I is applicable except as follows:
Replacement:
If the machine is fitted with a laser to indicate the
cutting line, the laser shall be of category 2M or lower
according to EN 60825-1.
Page 63 of 63
End of Test Report 17706687 001 Part II of II
EN 61029-2-1:2012
Result - Remark
Handle and wheels for
transportation are provided.
Provided on the machine
frame
Saw blades delivered with
the machine are complying
with EN847-1.
Verdict
P
P
P
P
P
P
P
P
P
P
P
P
P
P
N/A