Blade Guard - Jet JTS-315LA Operating Instructions Manual

Test Report No.: No.: 17706687 001
Part II of II
Requirement  Test
Clause
Page 51 of 63
EN 61029-2-1:2012
- Use push-sticks or push blocks: to
feed the workpiece past the saw blade;
- Use and correct adjustment of the
riving knife;
Use and correct adjustment of the
-
upper saw blade guard;
Rebating or grooving should not be
-
carried out unless suitable guarding,
such as a tunnel guard, is fitted above
the saw table,
- Saws shall not be used for slotting
(stopped groove);
A table giving guidance on spindle
-
speed selection for different materials
to be sawn shall be given for variable
speed tool;
- Use only saw blades for which the
maximum possible speed is not less
than the maximum spindle speed of
the tool and the material to be cut;
When transporting the machine use
-
only transportation devices and do
never use guards for handing or
transportation;
During transportation the upper part of
-
the saw blade should be covered; for
example by the guard;
The handbook or information sheet
-
shall contain information regarding: the
range of saw blade outside diameter,
thickness and bore diameter which
may be used with the tool;
How to support long workpieces;
-
Description of the residual risks;
-
Result - Remark Verdict