Jts315La - Jet JTS-315LA Operating Instructions Manual

Test Report No.: No.: 17706687 001
Part II of II
Requirement  Test
Clause
necessary to provide realistic emission levels,
tests shall be carried out under more than one
operating condition or set of operating conditions
as defined in the relevant Part 2.
If the tool is equipped with means or devices to
reduce the vibration emission in comparable
operating conditions, these shall be used, in
accordance with the user instructions, during
vibration testing. If this requires a deviation from
the type test method, this shall be reported and
explained in the test report.
During the measurements the hands of the
operator shall guide the machine as is necessary
by the design of the tool and as specified in the
instructions supplied with the machine.
13.3.6.2 Attachment, work piece and task
The attachment or accessories to be used with
the machine shall be as recommended in the
user instruction.
If these attachments are of a vibration reduction
type, it shall be reported together with the
declared vibration value.
Care shall be taken that the location of the work
piece on its support does not affect the results of
the test. Details for task and work piece are given
in the relevant Part 2.
NOTE It should be noted that even small differences
in size, shape, material, wear, unbalance, etc. of the
accessory can alter the vibration magnitude
considerably.
13.3.6.3 Operating conditions
Tools are tested under load only, unless the
operating condition no-load is considered as
important in practical use (no-load accounts for
more than 20 % of the time when tool is switched
on). In this case the tool shall be tested under
both load and no-load condition, or at a typical
work cycle containing load and no-load. The
relevant Part 2 describes the modes of operation
and the calculation of the declared emission
value.
The machine shall be operated at normal working
conditions and working modes according to the
user instructions, which shall be maintained for
the duration of the test. Those operating
conditions shall be used that are representative of
the highest vibration values likely to occur at
Page 24 of 63
EN 61029-1:2009+A11
Result - Remark Verdict
N/A
N/A
N/A
N/A