Jts315La - Jet JTS-315LA Operating Instructions Manual

Test Report No.: No.: 17706687 001
Part II of II
Requirement  Test
Clause
integrators, recording system, etc.);
h) position and fastening of transducers,
measuring directions and individual vibration
values when relevant (e.g. recorded by photos);
i) the arithmetic mean total vibration ah, for each
operator the total vibration value a
single axis weighted acceleration values a
good practice to report all the measured value
(i.e. for all axes of vibration, tests and operators);
j) the uncertainty K of the vibration total value a
Any deviations from the vibration test code in this
standard shall be reported together with the
technical justification for such deviations.
14 PROTECTION AGAINST INGRESS OF FOREIGN BODIES AND MOISTURE
RESISTANCE
14.1 Tools with marked degree of protection
14.2 Tools with degree of protection higher than IP20
14.3 Humidity treatment
Humidity (%) ............................................................: 93%
14.4 Spillage of liquid in normal use
Mains connection
Spillage test .............................................................:
Electric strength test .................................................:
14.5 Tools, except those of class III, intended to be
connected to a water supply shall be constructed
so that the electrical insulation of the tool is not
affected by water during recommended operation.
The tool is connected to a water supply and
operated at 1,06 times rated voltage for 5 min in
the most unfavourable position in accordance with
the manu a turer s instru tions.
Throughout the test the leakage current between
live parts and the enclosure as specified in 12.2 is
monitored. The leakage current shall not exceed
the value specified in 12.2.
Immediately after this treatment inspection shall
show that water has not entered the tool to any
Page 27 of 63
EN 61029-1:2009+A11
and the
hv
hw.
..................................................: 25C
Result - Remark
It is
.
h
IP44 tested according to EN
60529 and found ok
Not applicable
The tools are placed in
humidity cabinet for 48 hours.
Verdict
P
P
N/A
P
P
P
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A