Aligning The Blade Guard And Splitter; Table Insert; Motor Bracket And Motor Plate - Jet JWTS-10JF Operating Instructions And Parts Manual

Aligning the Blade Guard and Splitter

Referring to Figure 18:
1. Raise the blade guard away from the table and
hold the anti-kick pawls (A) away from the table
surface. A hex wrench (B) works perfect for this
application.
Using an accurate straight edge (C), align the
splitter with the saw blade, if required, as follows:
2. Set an accurate straight edge (C), against the
saw blade (D) on the right side as shown in
Figure 17. Be sure that the straight edge rests
against the body of the saw blade and not the
saw teeth.
3. Loosen two hex cap screws (F) securing the
splitter bracket and adjust the splitter (E)
sideways until alignment with the saw blade is
achieved.
4. Tighten the hex cap screws (F).
5. Slide the set block forward or back and then
make sure the splitter is level with the table and
approximately 1/8" above the table before
tightening the rest of the hardware. 1/8" space
allows the blade guard assembly to turn to a
45º angle without contacting the table.
6. Check the alignment again after tightening the
hardware. Realign if necessary.
Use a square to verify that the splitter is
perpendicular to the table surface and adjust if
required.

Table Insert

Referring to Figure 19:
1. Raise the blade guard assembly.
2. Lower the blade completely.
3. Place the table insert into the opening with the
notched end (B) towards the splitter (C).
4. Adjust the table insert flush with the table by
turning four leveling setscrews (D) and using a
straight edge (E). A 3mm hex wrench is
required to adjust the setscrews.

Motor Bracket and Motor Plate

1. Place the motor bracket (A, Fig. 20) onto two
connecting rods (B, Fig. 20) and secure by
tightening two setscrews already installed in
the motor bracket.
17
Figure 18
Figure 19
Figure 20